Dpofirs AV Multi Out to Component Video/Audio Cable Cord For PS2 PS3,Audio/Video Cable,Ultra Thick and Flexible PVC Jacket,Component Video/Audio Cable Cord,Audio/Video Cable

Product Information

If you are chasing image quality perfection on the PS1, then you should use the beetle PSX core in retroarch with a CRT-royale kurozumi shader.

Note: You must add a 220 uF capacitor in each of the RGB lines (+ towards console) to get an acceptable picture. If you don't, the picture will be too dark and you won't like it!! Connect the output from this device to a video upscaler which can scale to 480p (or higher) which can support very large majority of modern equipment. Note: supported since 3.50 and not available on SDTV (480i/P & 576i/P) resolutions / output connectors.

Select the input connector on the audio device. Channel numbers and audio formats that are supported vary depending on the connector in use. Insert the colored connectors on the Wii Component Video cable into the input connectors on the television:

For reference, here's the pinout I use to connect all my systems to my monitors. A single common pinout means I don't need a seperate monitor cable for each system. If you change the audio output settings, the system will no longer be able to output audio from multiple output connectors at the same time. For example, if your system is connected to a TV via an HDMI cable and to an audio device via a digital optical cable and you switch to [Optical Digital] under [Audio Output Settings], audio will no longer be output from the TV. To output audio from the TV, switch the setting to [HDMI], or select (Settings) > (Sound Settings) > [Audio Multi-Output] and set the option to [On]. Some PlayStation®2 or PlayStation® format software titles may perform differently on the PS3™ system than they do on PlayStation®2 or PlayStation® systems, or may not perform properly on the PS3™ system.Insert the colored connectors on the Wii AV Cable into the input connectors on the TV. Plug the colored connectors into the following inputs: If a device that is not compatible with the HDCP (High-bandwidth Digital Content Protection) standard is connected to the system using an HDMI cable, video and/or audio cannot be output from the system. Gigabit Ethernet 1000BASE-T (IEEE 802.3ab) 8P8C connector following TIA/EIA-568 wiring standards with support for Auto MDI-X, which means Cat 5 and Cat 6 cables can be used without the need for special crosscables.

When using an HDMI cable, only [Linear PCM 2 Ch.] audio will be output from PlayStation®2 and PlayStation® format software. To output Dolby Digital or DTS® audio, you must connect the PS3™ system and the audio device using a digital optical cable and switch to [Optical Digital] under [Audio Output Settings]. Note: The Wii console supports Dolby Pro Logic II for simulated surround sound. If you have a surround sound stereo and wish to use this feature, you'll need to configure the Wii console to use surround sound. Complete these stepsThe PlayStation 2 can do VGA through this port, however it is software controlled, and since there aren't enough pins for H+V Sync, it uses Sync-On-Green, which not all monitors support. SyncBaby is a compact and efficient SNES AV Multi-out to VGA D-Sub (with 3.5mm audio-ouput) for your Super Nintendo to output 15Khz (240p) RGB. Linear PCM 2 Ch.] audio is set to be output from all output connectors by default. If you change the audio output settings, audio will be output only from the connectors that were set.